Easily set up your portable rugby posts.
Note: in windy conditions, supplied guy ropes can be used to provide additional support and stability

Packapost Portable Rugby Posts in Storage Bags

Step 1:Remove Uprights from bags

Step 2: Unroll the upright onto a flat surface

Step 3: Layout uprights as shown ensuring hose is not twisted.

Step 4: Remove the dust cap and turn valve fully anti-clockwise (toward inflate mark) which closes the valve and retains the air in the hose after inflation

Step 5: Connect the hose of the air pump (to the bottom connector) ad pump to FULLY INFLATE uprights. Replace dust caps on valves.

Step 6: Lay out uprights as shown, ready to connect crossbar

Step 7: Assemble crossbar

Step 7 (details): Slot together crossbar pieces. IMPORTANT – FULLY ENGAGE PUSH BUTTON spring clips into each of the holes in the crossbar end sections.

Step 8: Connect crossbar to upright. IMPORTANT – FULLY ENGAGE PUSH BUTTON spring clips into each of the holes in the upright connector.

Step 9: Raise posts to upright position

Step 9: Raise posts to upright position

Step 10: Anchor the post using supplied fixings - ground anchors for grass & water bags for turf

Voila! Your posts are up and ready to go.
Optional Additions:
1. Once the crossbar is attached to the uprights (Step 6), attach the supplied guy ropes to the uprights as shown.
* This is important on windy days.
2. At this point, you can also screw in flag holders into the top of the uprights.
Note: flags NOT INCLUDED
